>>> About Us
Aviation Low-intensity obstruction lights
ZOM-75W-AV™ >10cd, ICAO type «A»
“ZOM-75W-AV” low intensity obstruction light is a
light signaling equipment module, combining excellent optic-physical
characteristics, vandal-proof frame and availability. This item proved itself
to be a reliable solution with excellent performance data. Model was introduced
in 2006 and no warranty claims were made during the last service period.
Advantages of this model are as follows: modern shock-proof frame and attractive
price. This obstruction light model has a design, identical to “ZOL-2” obstruction light,
manufactured by “GSTZ” till 1991. Quality supervision on all manufacture and
shipment stages provides complete exclusion of defective goods claims.
Purpose of the device:
“ZOM-75W-AV”™ low intensity, type “A” obstruction lights are
intended for marking high-rise objects (obstructions) potentially dangerous for
air traffic: tall buildings and structures, smoke-stacks, telecommunication
towers, mobile communications relay masts, water towers, chimneys, power lines, cooling towers, crane
installations, bridge supports, structures located in airports vicinity.
install, several mounting sets available;
International Standards and Recommended Practices: Aerodromes – Annex 14 Volume
1, 5th Edition, July 2009, Chapter 6: Low-intensity, Type “A” Fixed Obstacle Light.
Colour aviation red;
radiation pattern: 360°;
radiation pattern: the norm value of 16°, the actual value of 65°;
intensity in the + 6°: the actual value of 38 cd;
intensity in the + 10°: the actual value of 52 cd;
· The intensity in the direction of -6°: the actual value of 46 cd.
voltage range, U (in): 220V AC;
power consumption: 150 W.
Performance: W1 –
For operation in
all macroclimate areas on land and at sea;
intensity obstruction lights are resistant to frost, rain, salt spray, dynamic
dust, vibration stress, solar irradiation, acute temperature changes (thermal
Degree of protection
temperature range -60°C to +50°C.
Wind load with
MS-EV60 mounting kit @ 200 km/h less than 40 N;
red of impact-resistant polycarbonate optical UV stabilizer DOW® (Switzerland);
shock-resistant polycarbonate with UV stabilizer Bayer Makrolon® (Germany);
Weight: not more
than 1,0 kg.
General requirements to installation and exploitation:
intensity obstruction lights are attached by means of a carrier unit (tubular
mast) with outer threading G 3/4”. “ZOM-75W-AV”™ obstruction
lights contain a 40W electric incandescent lamp which requires replacement if
burned out during the service life duration. Upon “ZOM-75W-AV”™ low intensity obstruction lights assembly it is
necessary to observe that the rubber seal is installed in place. Light filter
cleaning is to be performed if and when it is contaminated by means of clean
cotton, soft flannel or wash leather without any solvents and abrasive
substances. After cleaning the light bowl is to be wiped by cotton, slightly
moistened in alcohol.
Obstruction lights packing
under GOST 23216 for storage conditions 2 (c) GOST 15150. “ZOM-75W-AV”™ obstruction lights are
packed in transport tare, providing protection from mechanical damage and
In order to ensure safety
during exploitation of “ZOM-75W-AV”™ obstruction lights it is
Replace the lamp with light sources having lower luminous intensity index;
Perform any works on “ZOM-75W-AV”™ obstruction lights while
voltage is connected’
Assemble and operate obstruction lights with compromised insulation.
We guarantee faultless device operation during 5 years
in case of service regulations compliance!
Payment and Delivery:
We perform shipping to any region on Incoterms-2010
Terms and delivery conditions are discussed individually.
Settlements are made by means of a bank transfer with
an advanced contract on delivery.
For purchase, please contact: firstname.lastname@example.org