>>> About Us
Aviation Low-intensity obstruction lights
ZOM-75W™ >10cd, ICAO
low intensity obstruction light is a model combining excellent optic and
physical characteristics, proved by a 10 years lighting fitting frame warrantee
with availability. This item proved itself a reliable solution with excellent
performance data. Model was introduced in 2010 and during last exploitation
period, no claims were made. Advantages of this model are as follows: modern
small-scale and light but durable frame, proved by time and attractive price.
“ZOM-75W” obstruction lights filter is equipped with an echelon lens. Quality
supervision on all manufacture and shipment stages provides complete exclusion
of defective goods claims.
Purpose of the device:
low intensity, type “A”
obstruction lights are intended for marking high-rise objects (obstructions)
potentially dangerous for air traffic: tall buildings and structures,
towers, mobile communications relay masts, water towers, chimneys, power lines, cooling towers, crane
installations, bridge supports, structures located in airports vicinity.
install, several mounting sets available;
International Standards and Recommended Practices: Aerodromes – Annex 14 Volume
1, 5th Edition, July 2009, Chapter 6: Low-intensity, Type “A” Fixed Obstacle
Colour aviation red;
radiation pattern: 360°;
radiation pattern: the norm value of 16°, the actual value of 34°;
intensity in the + 6°: the actual value of 34 cd;
intensity in the + 10°: the actual value of 16 cd;
· The intensity in the direction of -6°: the actual value of 43 cd.
voltage range, U (in): 220V AC;
power consumption: 75 W.
W1 – all climate;
operation in all macroclimate areas on land and at sea;
“ZOM-75W”™ low intensity obstruction lights are
resistant to frost, rain, salt spray, dynamic dust, vibration stress, solar
irradiation, acute temperature changes (thermal impact);
of protection IP 65;
temperature range -60°C to +50°C.
load with MS-EV60 mounting kit @ 200 km/h less than 40 N;
transparent, red of impact-resistant polycarbonate optical UV stabilizer DOW®
material: shock-resistant polycarbonate with UV stabilizer Bayer Makrolon®
not more than 0.3 kg.
General requirements to installation and exploitation:
intensity obstruction lights are attached by means of a carrier unit (tubular
mast) with outer threading G 3/4”. “ZOM-75W”™ obstruction
lights contain a 75W electric incandescent lamp which requires replacement if
burned out during the service life duration. Upon “ZOM-75W”™ low intensity obstruction lights assembly it is
necessary to observe that the rubber seal is installed in place. Light filter
cleaning is to be performed if and when it is contaminated by means of clean
cotton, soft flannel or wash leather without any solvents and abrasive
substances. After cleaning the light bowl is to be wiped by cotton, slightly
moistened in alcohol.
Obstruction lights packing
under GOST 23216 for storage conditions 2 (c) GOST 15150. “ZOM-75W”™ obstruction lights are
packed in transport tare, providing protection from mechanical damage and
In order to ensure safety
during exploitation of “ZOM-75W”™ obstruction lights it is forbidden to:
the lamp with light sources having lower luminous intensity index;
any works on “ZOM-75W”™ obstruction lights while voltage is
and operate obstruction lights with compromised insulation.
We guarantee faultless device operation during 10
years in case of service regulations compliance!
Payment and Delivery:
We perform shipping to any region on Incoterms-2010
Terms and delivery conditions are discussed
Settlements are made by means of a bank transfer with
an advanced contract on delivery.
For purchase, please contact: firstname.lastname@example.org